Hayward Salt System Reset. Hayward Salt System Manual The first step to resetting the Hayward Salt and Swim system is to turn off the power to the system It's important to follow the manufacturer's instructions.
AquaRite Settings and Frequently Asked Questions YouTube from www.youtube.com
The process is actually very similar to the calibration steps above, but with some slight variations. To reset the salt reading, turn the unit off and then back on, waiting for 5-10 seconds
AquaRite Settings and Frequently Asked Questions YouTube
Changing out the circuit board will also require a salt level reset The salt level may not match the actual pool level, and if the salt cell is clean but the salt reading is low, the Inspect Cell LED should be manually reset by pressing and holding the Diagnostics button until the LED goes out (approximately 3 to 5 seconds). Everything was running fine but recently the average salt reading shows low
Hayward Pool Salt Generator Systems. This can be done by switching off the circuit breaker that powers the system Locate the power supply for the salt system and switch it off.
How to clean your Hayward Salt Chlorination Turbo Cell Canada, Goldline. Changing out the circuit board will also require a salt level reset The instant reading stays at this level while the average reading goes down